This command will let you adjust the position of second relay shown on the plot. When you add a second relay to the DS Relays Window with one the commands under the Add menu, you can specify the origin and orientation of the second relay. This Second Relay Origin Command lets you change the position of the second relay characteristics at any time if the default position does not suit your needs.
TO SPECIFY THE POSITION AND ORIENTATION OF THE SECOND RELAY CHARACTERISTICS:
1. Select the Edit | Second Relay Origin command.
Note: The menu item is dimmed and cannot be activated if the characteristics of only one relay are being displayed.
A dialog box will appear.
2. Specify the position of the origin for the second relay.
Enter the coordinates in polar form; with the magnitude (in primary ohms) and angle (in degrees) in the “Ohm” and “Deg.” edit boxes, respectively.
3. Select the orientation.
Click on "Forward" to display the second relay characteristics with a forward orientation. Click on “Reverse” to display in the opposite orientation.
4. Press OK to close the dialog box.
The second relay will be redrawn with the new origin and orientation you specified.
DS Relays Window
EDIT MENU